SHOP

DIY Skill Level:  Intermediate ~ Expert

Recommended Working Room Temperature: Above 68 F° (20 C°)  

We are not responsible for any damages caused by improper or incorrect use of this product.  

Please read installation instruction carefully before applying this protective film on to your watch. Result may vary, proper installation will protect better and last long. 

• 1. Use alcohol or watch cleaning solution with soft scratch free material such as lint free microfiber towels to clean your watch thoroughly. Make sure all surface is spotless clean before applying. Left on stains, fingerprints can result in discoloration or cause peeling problem. 

• 2. Prepare distilled or purified water (Plain bottle water recommended) and pour it into the spray bottle included in the package. You may choose to use purified water filled in a cup as well.

• 3. Peel off protection film from the kit using the tweezer and spray water on sticky side or dip it in the water. Make sure to remember which side is the stick-on part that goes on to the watch surface. You may choose to spray water directly on the watch surface and attach film but please make sure your watch is capable of water resistant. 

• 4. Place it on the correct part of the watch. Carefully align protection film to fit within the edges and borders. Using your fingertips or smooth part of the tweezer to slowly push out waters and air bubbles with gentle pressure motion starting from the center of the protection film, then absorb the pushed-out water with lint free cloth or paper towel. If you fail to fit and align protection film on the watch surface, immediately remove using tweezer and re-spray or dip it in the water, then repeat above steps. 

• 5. Each piece needs at least 3 to 30 minutes of drying time to be securely set on the watch surface, so carefully finish to work on other parts of the watch using above techniques to complete the setting process. Completing the setting process is not a completion of installation process. DO NOT WEAR YOUR WATCH! Time varies by watch type, but you will need a minimum of 24 hours or more to have it completely dried. 

• 6. After completing the final drying process, check for any gaps or air bubbles, then press the protection film firmly once again using your fingertips. Some water spots and air bubbles will disappear in few more days. Please do not force to peel off protection film and try to re-apply. 

Congratulations! Enjoy Royal Watch Skin

* Please note, some water spots and air bubbles will disappear in few more days or weeks

* We are not responsible for any damages, defects or malfunction caused by misuse, abuse or improper maintenance, failure to follow operating instructions, or use with equipment with which it is not intended to be used