SHOP

DIY Skill Level:  Intermediate ~ Expert

Recommended Working Room Temperature: Above 68 F° (20 C°)  

We are not responsible for any damages caused by improper or incorrect use of this product.  

Please read installation instruction carefully before applying this protective film on to your watch. Result may vary, proper installation will protect better and last long. 

• 1. Remove the golf club head from the shaft or make sure that your golf club does not move when applying the protection film. Clean your golf club using soft scratch free material such as lint free microfiber towels. Make sure all surface is spotless clean before applying. Left on stains, fingerprints can result in discoloration or cause peeling problems. 

• 2. Prepare distilled or purified water (Plain bottle water recommended) and pour it into the spray bottle included in the package. 

• 3. Protection film is in 3 layers. Remove top clear cover film and peel out middle layer which is the actual protection film using tweezer or fingers.

• 4. Spray plenty of water on sticky side of the film and the club surface. Some parts are easier to apply without the water so use any method that works for you. Place it on correct part of the watch then carefully align protection film to fit within the edges and borders.  

• 5. Using your fingertips, tweezer or plastic scraper to slowly push out waters and air bubbles with gentle pressure motion, then absorb the pushed-out water with lint free cloth or paper towel. If you failed to fit and align protection film on the club surface, immediately remove using tweezer and re-spray water, then repeat above steps. Carefully finish applying all parts of the club to complete the setting process. Completing the setting process is not a completion of the installation process. 

• 6. You may use low heat from the hair dryer to evaporate water faster and cure but please be careful, overheating can damage the film.

• 7. DO NOT USE YOUR CLUB. Time varies by club type, but your will need a minimum of 24 hours or more to have it completely dried.

• 8. After completing the final drying process, check for any gaps or air bubbles, then press the protection film firmly once again using your fingertips. Some water spots and air bubbles will disappear in few more days or weeks. Please do not force to remove protection film and try to re-apply.

Congratulations! Enjoy Royal Club Skin

* Please note, some water spots and air bubbles will disappear in few more days or weeks

* If you decide to remove the protection film in future, please warm up your golf club using the hair dryer and remove it slowly to avoid any damages

* We are not responsible for any damages, defects or malfunction caused by misuse, abuse or improper maintenance, failure to follow operating instructions, or use with equipment with which it is not intended to be used