SHOP

DIY Skill Level: Beginner

Recommended Working Room Temperature: Above 68 F° (20 C°)   

We are not responsible for any damages caused by improper or incorrect use of this product.   Please read installation instruction carefully before applying this protective film on to your watch. Result may vary, proper installation will protect better and last long.   

• 1. Use wet towel or special cleaning solution with soft scratch free material such as lint free microfiber towels to clean your luxury item parts where you want to apply Royal Luxury Skin thoroughly. Make sure all surface is spotless clean before applying. Left on stains, fingerprints can result in discoloration or cause peeling problem.  

• 2. Prepare distilled or purified water (Plain bottle water recommended) and pour it into the spray bottle included in the package. You may choose to use purified water filled in a cup as well. 

• 3. Peel off protection film from the kit using the tweezer and spray water on sticky side or dip it in the water. Make sure to remember which side is the stick-on part that goes on to the luxury item surface. Spraying water directly on to your item is not recommended. Water damage can be appeared depending on the material you are working on so please be carefull.

• 4. Place it on the correct part of the item. Carefully align protection film to fit within the edges and borders. Using your fingertips or smooth part of the tweezer to slowly push out waters and air bubbles with gentle pressure motion starting from the center of the protection film, then absorb the pushed-out water with lint free cloth or paper towel. If you fail to fit and align protection film on the watch surface, immediately remove using tweezer and re-spray or dip it in the water, then repeat above steps.

• 5. Each piece needs at least 3 to 30 minutes of drying time to be securely set on the surface, so carefully finish to work on other parts of the item using above techniques to complete the setting process. Completing the setting process is not a completion of installation process. DO NOT USE YOUR ITEM! Time varies by item, but you will need a minimum of 24 hours or more to have it completely dried. 

• 6. After completing the final drying process, check for any gaps or air bubbles, then press the protection film firmly once again using your fingertips. Some water spots and air bubbles will disappear in few more days. Please do not force to peel off protection film and try to re-apply. 

Congratulations! Enjoy Innovshell

* Please note, some water spots and air bubbles will disappear in few more days or weeks

* We are not responsible for any damages, defects or malfunction caused by misuse, abuse or improper maintenance, failure to follow operating instructions, or use with equipment with which it is not intended to be used